If you are a fan of Disney then you will absolutely love this Mickey Mouse Christmas wreath! It is quick, easy, and anyone can do it!
One of the reasons that this craft is perfect is that it appeals to the little ones. Mickey Mouse is a fan favorite, just like all of Disney!
Mickey Mouse Christmas Wreath
If you or your little ones are on the search for a fun craft to do in your free time or to decorate the house, this Mickey Mouse Christmas wreath is definitely the way to go.
As far as supplies goes, you will not need anything that cannot be found at your local craft store. You may even have some of the ribbons and pins that you will need in your house!
Once you get started, it won’t be long until you will be finished with your wreath. It does not take long and the instructions are detailed and clear to give you the best result.
One of my favorite things about this Mickey Mouse Christmas wreath is that you can personalize it a little bit. Just like any other craft, there is always room for creativity.
If you would like to keep your wreath up, even when the Christmas season is over, you could totally do that! Just take off the Santa hat, replace it with a bow, and now it’s Minnie Mouse.
You could also take a look at this Mickey Mouse Wreath if you are looking for something that is not just for the holidays. You will love the result just as much as this one!
There is so much fun to be had with your Mickey Mouse Christmas wreath! The process and the end result are sure to put smiles on everyone’s faces!
If you love Disney, you should take a look at the Disney Paper Dolls or this Frozen White Hot Chocolate Recipe!
Mickey Mouse Christmas Wreath
One of my favorite things about this Mickey Mouse Christmas wreath is that you can personalize it a little bit. Just like any other craft, there is always room for creativity.
Materials
- 1 - 12-inch Foam Wreath Form
- 2 - 6-inch Foam Wreath Forms
- 1 Roll Black 3-inch Satin Ribbon
- 1 Roll Red 3-inch Satin Ribbon
- 2 - 2-inch Yellow Buttons
- 1 Santa Hat
- Floral Pins
Tools
- Scissors
- Painter’s Tape
- Hot Glue Gun & Glue
- Ruler
Instructions
- Using a ruler and the painter’s tape mark off the midpoint of the large wreath form.
- Hot glue one end of the red ribbon to one side of the halfway point marked by the painter’s tape, then begin wrapping the red ribbon around the wreath form snugly, periodically hot gluing it in place. Once you reach the other halfway point, hot glue the red ribbon in place and cut it off. Repeat on the other half of the wreath form with the black ribbon.
- Wrap the entirety of the two smaller wreath forms with the black ribbon, taking care to make sure it is snug around each form.
- Lay the large wreath in the center of your table and position the two small ears on either side of the black portion of the larger wreath, about 6-8 inches from each other. Using floral pins, affix the smaller wreaths in place.
- With an 8-10-inch section of black ribbon, wrap the spot where the small wreath and large wreath come together, then tie the ribbon in the back to further strengthen that joint.
- With the floral pins, affix the hat between the two ears.
- Hot glue the buttons on the bottom of the red portion of the larger wreath. Hang and enjoy!
